Teledex E Series Manuel d'utilisateur télécharger pdf (Page 12)

12 www.teledex.com E SERIES ANALOG USER GUIDE

When the handset is off-hook or the Speaker

key is engaged on the speakerphone, press the

volume control keys to increase or decrease the

volume. The handset volume control is an 8-step

operation. All models are hearing aid compatible.

RINGER VOLUME CONTROL

The ringer volume control switch is on the bottom

side of the phone.

The setting is either Low or HI (High).

INDICATORS

SPEAKER AND MUTE KEYS CONNECTING AND

STATUS INDICATORS

Speakerphones are equipped with LED indicators

to show the current feature key status.

• Press the Speaker or Mute key to use that

service—when in use the red LED lights up.

CALLING

PLACING A CALL USING THE HANDSET

• Lift the handset.

• Dial out by using the numeric dial pad or by

pressing a speed dial location.

RECEIVING A CALL USING THE HANDSET OR

SPEAKER

On a single-line telephone, when the phone rings,

lift the handset (or press the speaker key if you

have a speakerphone) to begin the conversation.

PLACING A CALL USING THE SPEAKERPHONE

The E Series speakerphones are equipped with

a high quality speakerphone feature to allow

hands-free operation. To use, simply press the

Speaker key when placing or answering a call.

The telephone line will activate automatically.

The Speaker key will light up indicating that the

speakerphone is in use. To hang up, press the

Speaker key again.

Programming

PROGRAM SPEED DIALS USING

SUBMERGED [STORE] AND [FLASH]

[Store] and [Flash] programming keys are located

under the faceplate and overlay. Access them by

lifting up the faceplate and overlay, using either a

paperclip or sharp pointer.

STORING A NUMBER INTO MEMORY

KEYS[STORE]

Each speed-dial location can store up to 32 digits

in tone mode.

Note: Flash programmed into memory counts as

one digit when storing a number.

1. Lift the handset.

2. Press the STORE key.

3. Enter the number to be stored using the

numeric dial pad.

4. Press the desired memory location where

the number is to be stored.

5. If additional numbers are to be stored,

repeat steps 3 through 5.

6. Hang up the handset.

PROGRAMMING FLASH TIMING

Flash timing options are 100 ms through 1000

ms, programmable in 100 ms increments. The

default Flash timing is 600 ms.

1. Lift the handset.

2. Press the STORE Key once.

3. Program FLASH by pressing 1 for 100 ms,

2 for 200 ms, etc.

4. Press STORE.

5. Press FLASH.

6. Hang up phone to exit programming.

PROGRAMMING PAUSE TIMING

Pause timing options are 1 second through 5

seconds, programmable in 1 second increments.

The default pause timing is 3.5 seconds.

E100 AND E100TRM PHONES

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Commentaires sur ces manuels

Pas de commentaire